OM0249
Page 20 of 64
Rev 4 June/2020
•
Touching a “Text” button command. The text or numerical value will be in blue indicating that is a link
similar to the computer or on the internet. The system settings menu screen shown below is a good
example of both the Text commands and Button commands:
Note:
The Main Screen is the one exception for the above described buttons.
The green clock text is and is a link to adjusting the time.
The large white Control system measured values are also a “second” link to the “Environmental
Set-Points” menu and the control system descriptions are a link to system description pop up
screens when touched.
8.3.5
Functioning accessed from the System Settings screen:
The “System Settings” menu screen can be accessed from the “Main Screen” by touching the NUAIRE logo:
Environmental Set-Points:
Allows adjustment of Temperature, CO
2
, Door, and Perimeter heater power level
settings.
Note:
You can also access the Environmental set points by touching any
control system numerical value in the MAIN SCREEN.
Performance Monitor:
Views a function’s Set-Point and Measured values over the last seven days.
Service Settings:
Protected by the password 9876, it facilitates Calibrations, Option settings,
and access to Diagnostics.
System Information:
Views the units Model Number, Serial Number, Control board assembly (CCBA)
Software Revision and the Display board assembly (LCBA) Software Revision.
Display Settings:
Brightness: Allows adjustment of the screen brightness.
Slide right to increase / left to decrease
Calibrate:
Press button to access screen calibration - follow screen prompts /
target symbols.
Save:
Remember to press the “Save” button after making changes or
calibrating the screen. They will be lost if “Cancel” is pressed to exit
the screen.
Set Password:
A 4 digit password can be set and will protect access to Environmental Set points,
running Decon cycles, and changing the password. See section 8.3.7 for instructions
to set the User Password.
Decon:
Begins Decon setup instructions and starts the heated Decon Cycle when pressed.
Also, it advances through the phases of the Decon Cycle.
System Settings Screen
Summary of Contents for NU-5710
