![background image](http://html1.mh-extra.com/html/nu-flame/synergy-perspective-bf/synergy-perspective-bf_use-installation-and-servicing-instructions_1715507032.webp)
32
n.
Firstly, carefully place the remainder of the natural coloured
vermiculite granules (from the large bag) around the bark chips
and logs so that none of the fuel tray is visible.
Secondly, sprinkle the reminder of the black vermiculite granules
(from the small bag) over the same area.
Ensure that any Vermiculite granules that fall onto the ported
(holes) area of the Burner are removed.
! IMPORTANT NOTE !
Check that No Vermiculite Granules or Bark Chips are on the ported (holes) area around
the burner.
o.
Remove the Embaglow from the packet provided and now thin out the strands of material. Working between the logs place
strands on top of the Vermiculite on the central Burner area. Placing the material between the logs will allow the flames to make
the material glow.
Note.
Ensure that no stray Embaglow material is left close to the pilot. The spark from the ignition system will track down even a
single strand of Embaglow and prevent the spark from arcing to the pilot.
p.
Before sealing the glass outer door with the 2 screws and the Pozidriv screwdriver provided, check the condition of the glass
and ensure it is clean and free from any finger marks.
17.0 - TESTING, COMMISSIONING & USE
! IMPORTANT NOTE !
During its first period of use any protective coatings and oils will burn out of the fire and it is wise
to ventilate the room for the first hour; also advise the customer that this may persist for the first
few days until the fire is fully burnt-in.
17.1 - LIGHTING THE FIRE
a.
Reference to Section 2 in the Users Instructions ’Lighting & Controlling the Fire’ will show how to light and operate the fire.
b.
Check that the supply pressure to the fire is at the pressures required, 20mbar (Natural Gas G20) or 37mbar (Propane G31)
when set at high.
! IMPORTANT NOTE !
Ensure that the pressure test point used is sealed and gas tight.
17.2 - FITTING THE OUTER STEEL OR GLASS DOOR OPTIONS AND DÉCOR PANEL
a.
Fit the décor panel above the glass door onto the magnets as shown.