3
1.0 - PACK CONTENTS
The Fire Will be Supplied on a Small Pallet with Additional Boxes.
The Very Large Box contains: Main Casing (with Riser Plate if ordered), Sealing Frame (if ordered) and Main Door
(all assembled together), Fuel Tray and Radio Frequency Handset (as ordered either Thermotronic or Thermostatic
Thermotronic), Cable Fixing System and Screwdriver (for unscrewing the Inner Glass Door).
1.1 - Unpacking
a).
To make the fire more manageable and prevent the possibility of damage it makes sense to remove various
Trim parts, Doors (Glass Doors specifically) and the Burner Assembly prior to Installation as detailed below.
Note: If the Fire is to be Installed in a Fire Surround a Riser Plate Must have also been ordered and will already be
fitted to the base of the fire.
This is very important because without the riser plate the Outer Door will foul on the Hearth.
b).
Additional boxes contain: Log Set (Dark Wood or Silver Birch), Sand Coloured Bark Chippings, Black
Coloured Bark Chippings, Large Bag of Natural Coloured Vermiculite Granules and Small Bag of Black Coloured
Vermiculite Granules & a Pack of Embaglow.
c).
If a Wall Mounted Fire with Wall Mounted Television has been advised then a TV Glass Heat Shield will have
been supplied and if the Synergy Glass has been ordered the Glass Shelf will also have been supplied with the Sealing
Frame.
Important: Store the Trims and Doors in a safe secure area as all parts will have been Quality Control checked
prior to dispatch and Nu-Flame will not accept Claims for damage that occurs on site.
Important: Store the Trims and Doors in a safe secure area as all parts will have been Quality Control checked
prior to dispatch and Nu-Flame will not accept Claims for damage that occurs on site.
The Glass Doors (if ordered) should be stored such that the glass is not prone to being chipped or scratching.
1.2 - Removal of Components
a). Fires Ordered with Steel or Glass Trims
i) The Outer Door will have to be removed and stored carefully to allow access for removal of the other components.
ii) Open the outer door by pulling at the left side to release it from the magnetic catches and open the outer door.
iii) Now at the hinge end push out the two Hinge Pins to release the Outer Door.
iv) The Sealing Frame (if ordered) can now be removed by removing the 6 fixing screws.
v) Now use the Screwdriver provided remove the 2 screws securing the Inner Glass Door, push out the Hinge Pins.
vi) Remove the 4 screws securing the burner mounting plate assembly; then lifting at the rear, swing the whole
assembly out and clear of the fire. Take care not to mark the liners in the fire.
Note: These small parts must be placed in a safe area as they will be required later.