Line up the tabs on the horizontal mounting
bracket with the two mounting cutouts located
on the back of the backer. Lift the fireplace into
position and make certain the tabs are locked
into the mounting holes and the unit is seated
securely on the wall. The tabs on the vertical
bracket will sit under the backer.
Place the burner cup into the burner holder,
Make certain the burner is well seated and
sitting level.
Screw in the two smallest screws to secure the
unit to the wall. These screws have one small
washer each. Align the vertical mounting tabs
at the bottom of the fireplace with the screw
holes, thread and tighten the screws to secure.
The burner is filled with a high heat ceramic fiber. Do not remove the ceramic fiber from inside the burner.
Use only a recommended Ventless Fireplace Fuel like “Nu-Flame Bio-Ethanol Fuel”. Make certain the
sliding dampener on the burner slides easily back and forth and is completely open prior to filling. Make
certain the burner is clean and free of dirt or packing debris. Pour fuel into the burner using a funnel. The
burner should be no more than 2/3 full. DO NOT OVERFILL. Wipe up any spilled fuel. Use a long match or
extended lighter to ignite the fuel.
Use the included snuffer tool to extinguish the fire.
CAUTION: The flame starts out slowly. Please allow 15 minutes to reach the optimum
temperature and flame height. DO NOT ASSUME THE FUEL DID NOT IGNITE. Follow the refilling
instructions in this manual.
