NTI VOPEX SERIES DVI SPLITTER/EXTENDER
9
CONNECT THE CATX CABLE
Make sure the CATx cable has been installed in accordance with the “Preparation for Installation” instructions on page 5.
Connect a CATx cable to one of the ports marked “CATx Output” on the VOPEX. Connect the other end of that cable
to the “Cat x” port on a Remote Unit. When properly inserted the CATx cable end should snap into place.
Repeat for each remote unit installed.
WARNING: Never connect the XTENDEX to an Ethernet card, Ethernet router, hub or switch or other
Ethernet RJ45 connector of an Ethernet device.
Damage to devices connected to the Ethernet may result.
Figure 4- Connect a CATx cable between the VOPEX and each Remote Unit
Note: For best results, use CAT6/6a cable when audio support is required. CAT5e/7 cable supports audio only to
150ft.
!