NTI VEEMUX AUDIO/VIDEO MATRIX SWITCH
30
Outputs Scanning Sequences
Figure 19- Outputs Scanning Sequences page
The Outputs Scanning Sequences page (accessible only to the Administrator) displays the configuration of an automatic switching
sequence from input (video source) to input for each output (monitor).
The page displays:
output number being configured
the Scanning Sequence function status for that output
the Scan Mode status of each input (ON/OFF)
the length of time in seconds (dwell time) that each input will be viewed when connected
The output selection at the top of the page can be changed to any output to display the Scan Sequence Input selections and dwell
times for that output.
The inputs and the amount of time that each will be viewed (0-32000 seconds) can be set to cycle sequentially for each connected
output. If an input is set to 0 seconds, the sequence status will display “OFF”, and the input will be omitted from the scanning
sequence. To include an input in the sequence, enter a dwell time period from 1-32000 seconds, and press
Apply
.
To quickly clear all dwell time settings, press the
Clear All
button at the bottom of the page. All sequence settings will change to
“OFF” and all dwell time settings will change to 0.
To enable the scanning sequence for the output shown, place a checkmark in the “Sequence Enable” block.
Tip: To quickly enable the scan sequence for multiple outputs, use the “Sequence Enable” blocks found on the Switch
Page (page 18).
Note: If only 1 input is set to Sequence “ON”, then the output connection to that input will not change when the Scanning
Sequence is enabled.
Note: If the scanning sequence for an output is enabled through the web interface, then the Scan Mode for that output
as configured through the LCD menu (page 9) will be disabled.
