Trinity Lx
│
Installation and Operation Instructions
Lx – WH Series
10
Figure 3-2(a) Wall Mounting Installations (Lx200WH)
Remove the upper wall mount bracket from the
back of the water heater.
Failure to follow instructions may
result in fire, serious injury, or death.
Secure the upper wall mount bracket to a solid
wall using field supplied lag screws (anchors
when mounting on a concrete wall) that are
adequate to support the weight of the water
heater. Ensure the bracket is mounted in the
level
position.
Refer
to
Table
2-1
Specifications for water heater weight.
This unit requires two people to lift it
or damage and injury may result.
Mount the water heater to the bracket by
aligning the slots in the back of the water
heater with the hooks protruding from the wall
bracket. The top of the slots must rest at the
bottom of the groove in the hooks of the wall
mount bracket.
Pull the bottom of the unit away from the wall
to allow the installation of the lower wall
mount bracket (included with water heater).
The bracket will snap into place using the slots
provided in the bottom of the unit (ensure the
snaps lock into place, once installed the bracket
should not be easily removed).
Code requires all wall mounted instantaneous water heaters to be installed with suitable
wall protection extending the full length and width of the water heater. Check with local
authorities regarding acceptable protection materials.
1” Clearance for Vent and
Hot Water Piping.
Ensure that the top of each
slot rests on the bottom of the
grooves in the wall bracket.
Bottom Bracket is in
Lx Installation Kit Box
