NTI E-AVDS-4G1, Installation And Operation Manual, Page: 8 / 11

8
3
. Program the Tele phone numbers and A larm methods for each
This dialer supports two alarm methods: voice alarm and SMS alarm
Under programming state, press E1, E2, E3...E8 to save alarm receiving numbers and alarm methods.
Example : number is 18965713028, choose voice alarm. Operation: E1
→
18965713028
→
ENTER
→
1
→
ENTER.
The dialer saves the number when the 1st “ ENTER ” is pressed.
Next enter the "1" for the alarm method, this chooses voice alarm. (For SMS alarm method, substitute a "2")
Next press
“ ENTER ” to save the alarm method.
If
"
∩
" and then “ 0 ” is displayed it means the input was correct and the dialer returns to a programming state “ 5 ” . User
can perform the operation again in state “ 5 ” .
To delete the 1st group number : Press E1
→
ENTER.
4. Check the telephone numbers and corresponding alarm method
Under programming state, press
“ 3 ” and then E1-E8 . The numbers and corresponding alarm method will be displayed.
Operation:
“ 3 ”
→
E1/E2/E3/E4
→
display
Displayed: the alarm method(1 or 2)
→
A
→
phone number, then hear a “ Du ” voice after display.
5. Save and playback the audio message
1. This dialer supports a 20 second voice message
. (A shorter message will have the best quality).
Under programming state ( “ 5 ” displayed), press “ 1 ” ( “
『
” displayed means begin recording), and then begin talking and
recording
→
after which you will hear "Du" (The dialer will stop automatically and playback the voice message after it
has finished recording).
The User can stop recording a message by pressing
“ ENTER ” during recording.
2. Playback the recorded message:
Under programming state, press
“ 3, 1 ” ( a “ p ” displayed means play), recorded message playback begins, and is ended
with a “ Du ” after finishing.
6. Save short text message (m aximum 70 bytes/letters can be entered )
Under the programming state, press
“ 2 ” then send an SMS message from a phone to the SIM card's phone number (no
more than 70 bytes/letters (phone number will be provided by the SIM card provider). If more than 70 bytes, it will only
identify the front 70 bytes.)
.
If “
∩
” displays after the message has been sent and a "Du" is heard, it means the message has been input and will return
to state “ 5 ” ;
If
“ E ” displays, it means timeout. You need to try again following the above steps after returning to state “ 5 ” .
(Note: Keyboard is not operable when waiting for message reply. You will need to wait 2 minutes if the message
times out. If you send a message to the dialer the first time and dialer fails to receive it may because of a
network fault. The User can send it again or start up the dialer again, allow the machine to search network or Esc
by pressing
“ ENTER ”. F or example: “ 2 ”
→
ENTER. The Default message text is “ DA-911LTE ALARM ” )