3
CONFIGURE THE JUMPERS
Configure the jumpers on the E-AVDS-4Gx to be triggered by either the Normally-Closed (N.C.)or Normally-Open (N.O.)
relay contact on the E-xD. In the image below, the jumpers are set for connection to the N.O. terminal.
To set the “normal” relay state to Normally-Open, apply the J1 jumper to the center and right pin, and J2 jumper to the
center and left pin. In this configuration, a relay closure will trigger an alert state, activating the dialer.
To set the “normal” relay state to Normally-Closed, apply the J1 and J2 jumpers to the center and left pins. In this
configuration, a relay open condition will trigger an alert state, activating the dialer.
CAUTION: TO PRESS THE RESET BUTTON, INSERT A NON-CONDUCTIVE MATERIAL BETWEEN THE
CIRCUIT BOARDS WHILE THE UNIT IS ON AND PRESS THE BUTTON. USING A CONDUCTIVE
MATERIAL MAY SHORT THE CIRCUIT BOARD AND DAMAGE YOUR DIALER, VOIDING THE
WARRANTY.
NOTE: The “VOLTAGE” jumper position is not used in conjunction with the E-xD.
With the jumpers properly set, and the rear panel securely mounted, re-assemble the case.
J1
J2
RESET
BUTTON
PRESS RESET BUTTON
TO RESET PASSWORD TO
“
0
911”
J1
J2
Summary of Contents for E-AVDS-4G1
Page 5: ...5...
