NTI AG LinMot E1030 Series, Installation Manual, Page: 10 / 12

Controller Series E1030/2030/4030
NTI AG Installation: E1030/E2030/E4030 series / 16.09.2005 Page 10/12
E1030
Single axes controller
E2030
2 axes controller
E4030
4 axes controller
Width mm (in) 90 (3.5)
Height mm (in) 330 (13)
Height without fixings mm (in) 295 (11.9)
Depth mm (in) 176 (7)
Weight Kg (lb) 2.5 (5.5) 2.6 (5.7) 2.7 (5.9)
Case IP 40
Storage Temperature °C -25…70
Operating Temperature °C 0…50
Max. Case Temperature °C 65
Power Supply Requirement
Power Supply motor
The calculation of the needed power for the Motor supply is depending on the application and the used motor(s).
The following table shows a recommendation for general applications.
Controller Voltage/ Power LinMot Switched- Power Supply Part-Nr.
E1000 1 motor 72 V / 300 W S01-72/300 0150-1942
E2000 Up to 2 motors 72 V / 600 W S01-72/600 0150-1943
E4000 Up to 4 motors 72 V / 600 W S01-72/600 0150-1943
Power Supply signal
24 … 48 V / 10 W
Regeneration of Power
The Exxxx controller don’t use a regeneration resistor. In most application the recuperated energy will not become
an issue. In cases where the motor power supply voltage will exceeds the voltage limits because of recuperation
an additional capacitor between ‘PWR motor’ and ‘GND’ should be used. Typical: 22’000 uF.
Ordering Information
Servo Controller Description Art. No.
E1030-DP Profibus DP Controller 1 Axis (72V/6A) 0150-1625
E2030-DP Profibus DP Controller 2 Axis (72V/6A) 0150-1626
E4030-DP Profibus DP Controller 4 Axis (72V/6A) 0150-1628