Asphalt and concrete cutters
Operation manual
page 9
issued
01/2017
1.8. List of used safety stickers
In accordance with requirement of regulation no. 22/1997 Sb. about technical requirements of products,
there are decals of safety marks and symbols placed on mentioned models of floor cutters (models – in
point 2.1.). Images of these decals are in accordance of appropriate technical
Č
SN directive.
The individual decal types are describe below, in the order of their placement on the machine. There is
explaining text attached to each decal and symbol below.
1.
Associated decal containing safety marks according to
Č
SN
ISO 3864 (symbol no. B.2.5, B.3.1 and NB.2.26), mark
according to
Č
S ISO 6405-1 (symbol no. 7.28) and information
for machine operation in practice.
Safety mark, symbol no. B.2.5 instructs the operator to wear the
ear protection for the whole time of operation.
Mark, symbol no. 7.28 instructs the operator to read manual
before starting operation.
Safety mark, symbol no. NB.2.26 instructs the operator to use
protective gloves as protection against vibration for the whole
time of operation.
Alert safety mark, symbol no, B.3.1 (exclamation mark) warns
the operator of danger risk.
Information for the operator how to acts when repairing,
cleaning or adjusting the machine.
2.
Decal of symbol no. 7.23 according to
Č
SN ISO 6405-01 (decal
marks the spot, which should be lubricated with grease,
according to operation manual).
3.
Decal of symbol no. 8.1according to
Č
SN ISO 6405-1 (decal
marks the spot, where the engine oil drain bolt is located).
4.
Associated decal containing warning mark no. B.3.1 according
to
Č
SN ISO 3864, further warning symbol and text of safety
orders important for operating the machine.
Warning safety mark, symbol B.3.1 (exclamation mark) warns
the operator of danger risk.
Symbol shows the cutting blade and shoe, which express:
WARNING, DANGER OF FOOT INJURY BY ROTATING
CUTTING BLADE“.
Written information of instructions for machine operation.
5.
Decal no. 7.25 according to
Č
SN ISO 6405-1
(symbol marks two lifting points = points that can be used for
hoisting the machine).
