Vibratory tampers
Operation manual
page
4
issued 05/2014
1. Check the machine thoroughly, repair all
failures before starting the engine. If the
failures cannot be repaired at the jobsite, do
not operate the machine.
2. Check the fuel system for leaking. Dripping
fuel poses fire hazard.
Starting and operation:
3. When starting the engine, take stable
position and held the grip firmly.
4. The controls must be in good order.
5. The operator must not leave from his
position when the engine is running.
6. Stop the engine before interrupting the
work. When parking the machine, secure it
from falling.
7. Stop the engine before refueling. Avoid
contact between fuel and hot parts of the
engine. Let the engine to cool down first.
8. Keep the fuel tank tightly closed. Close the
fuel tap when not in operation. Drain the
fuel before transporting the machine for
longer distances.
DANGER! Leaking fuel tank and distribution
may cause explosion. Replace these parts
immediately if damaged.
Jobsite:
9. No bystanders are allowed within the
operational range of the machine. Especially
children should be kept in safe distance.
10. No don operate the machine in areas with
explosion danger.
11. If operated in closed spaces (halls, tunnels,
deep digs), there should be ensured
sufficient ventilation.
12. High care should be paid at the edges of
digs, heaps or slopes in order to avoid
falling down.
13. Held and guide the machine with high care
in order to avoid hands injury caused with
contact with an obstacle.
14. Do not smoke, do not use naked flame. Do
not work close to flammables or in
explosion danger areas.
15. Avoid touching hot parts. The exhaust
silencer and other parts of the engine are
very hot during operation and touching them
can cause serious burns.
1.5. Maintenance and Service
1. Do not remove any covers or other safety
devices. In case this must be done because
of service, install all the parts back before
starting.
2. Use genuine spare parts only. Do not carry
out any modifications without prior written
approval of the manufacturer.
3. Stop the engine before servicing the
machine.
1.6. Transport and Storage
1. When loading and transporting the machine
fasten the machine properly on the carrier.
2. The vibratory tamper is to be transported in
upright position or laid on the face side
(with engine upwards). These positions are
also suitable for storing.
3. Prior to long-term storage: Conserve the
machine, cover it and store it at safe, dry and
ventilated place.
1.7.Testing
It is recommended to test the machine by
authorized service at least once a year or more
often if used under heavy conditions.
If necessary, carry out repairs of all possible
failures.
1.8. List of safety signs used in the machine
