11
Rear Panel Overview:
1. Mains Power Inlet, Fuse and Power Switch:
3-pin IEC input, fused [5mm x 20mm, 3.15A, 250V, Anti-Surge (T)], 90-250VAC, 50-60Hz <40W.
A spare fuse is located within the fuse holder – only replace with the correctly rated fuse!
2. Ethernet Computer Control Ports:
Neutrik EtherCON RJ45 network Ethernet ports accepts either a standard CAT5 cable or housed RJ45 connector for connection
to a computer. Connect to port 1 and daisy chain from port 2 to additional NST units or use a suitable network switch to control
multiple units simultaneously.
3. Balanced Analogue Audio Outputs / Digital AES Outputs*:
The analogue outputs are wired as follows:
Pin 1: Shield/Ground
Pin 2: Signal Hot (+)
Pin 3: Signal Cold (-)
*Digital AES outputs can be enabled from within the D-Net software, and run in pairs...
Outputs 1 and 2 are outputted together from output 1.
Outputs 3 and 4 are outputted together from output 3.
Outputs 5 and 6 are outputted together from output 5.
Outputs 7 and 8 are outputted together from output 7.
4. Balanced Analogue Audio Inputs / Digital AES Inputs*:
The analogue inputs are wired as follows:
Pin 1: Shield/Ground
Pin 2: Signal Hot (+)
Pin 3: Signal Cold (-)
*Digital AES inputs can be enabled from within the D-Net software, and run in pairs...
Inputs A and B are inputted together on input A.
Inputs C and D are inputted together on input C.
