x
Inspect the machine components for wear, loose
fasteners, or damage. Pay special attention to all
pivot points and moving parts.
x
Call an authorized NSS service center for repairs.
90 Day Maintenance
(Every 300 Hours)
Verify that all daily, weekly and monthly
maintenance has been performed.
Tighten Chain
x
Check the tension on the drive motor chain. If the
chain has more than ½” deflection, tighten as
needed.
x
Access too the bolts for the drive motor are on the
left side of the machine. There are two bolts on top
which are accessed through the holes as shown in
the picture above. There are also two bolts located
below the frame. A total of four bolts.
Lubrication
x
Lubricate the casters with an industrial grade
bearing grease. Failure to lubricate casters will
cause the machine to maneuver with difficulty and
premature failure of the caster will result.
x
Lubricate the drive wheel bearings with an
industrial grade bearing grease. The zerk fittings
on the bearings can be accessed from the front of
the machine.
x
Failure to lubricate drive wheel bearings will cause
the machine to maneuver with difficulty and
premature failure of the bearings will result.
x
Lube the drive motor chain with a small amount of
grease using a brush. A chain spray can also be
used.
x
NEVER
use your fingers to put the lube on the
chain.
Serious injury may occur.
x
Lubricate all moving parts as required with a small
amount of grease.
x
DO NOT
lubricate the Gas Spring shaft, it does not
require lubrication as it is self lubricating.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
