Audio Sync
An audio signal may be supplied to the TLC 16 console via the phono jack located on the
back of the unit. The audio signal can be used to synchronize the chases to the beat of the
audio and to affect the intensity of predetermined channels.
Synchronizing
Chase Patterns
To synchronize chases; activate the audio mode by tapping the Audio pad until the LED
above it lights. Now activate a chase pattern and move the Chase Rate control to the minimum
position. Move the Audio Sensitivity slide control slowly up until the desired effect is
achieved.
Programming
Audio Intensity
Effects
The Audio mode may be programmed to flash desired channels to the intensity of the audio
signal whenever the Audio mode is on by following these steps:
1.
Tap the Program pad until the LED above it lights. If the LED does not light, the memory
lock is on.
2.
Select channels to be affected by selecting the Latch Pads to light the respective channel
level LED, and set the rest of the latches to off.
3.
Tap the Audio pad to program the audio flash effects into memory.
Master
Controls
Each of the master controls, Audio Level, Chase Rate, Fade Rate and Master Level, can be
programmed to come up at preprogrammed level upon power up. To program a control,
follow these steps:
1.
Set the control to its desired level.
2.
Tap the program pad until its LED is lit.
3.
Touch both the up and down pads of the control. The program LED should go out and the
level is now programmed.
TLC 16
Programming Control Functions
Software Revision 1.00 version A and above
Audio Sync
NSI CORPORATION
Features and Specifications may change without notice
9