NSFOCUS ADS NX3 10000 Series, Installation Manual

Page: 22 / 46

NSFOCUS ADS Installation Guide
Copyright © NSFOCUS 16 V4.5R90F01SP07C236 (2019-11-19)
Table 1-7 Meanings of MGR LEDs in different states
LED Status Meaning
Green (first from left) Indicates that the switch board works properly.
Red (first from left) Indicates that the switch board works improperly.
Green (second from left) Indicates that the system works properly.
Red (second from left) Indicates that the system works improperly.
Status LED (ACTN)
Table 1-8 describes ACTN LEDs in different states. These LEDs are available only on ADS
NX5-10000. There are six ACTN LEDs, each of which indicates the IPMI connection status
of one service card.
Table 1-8 Meanings of ACTN LEDs in different states
LED Status Meaning
On (Orange) Indicates that the IPMI connection of the related board is normal.
Off Indicates that the related board has not set up the IPMI connection.
System LED
Table 1-9 describes the system LED in different states.
Table 1-9 Meanings of the system LED in different states
LED Status Meaning
Green Indicates that the system works properly.
Red Indicates that the system works improperly.
Link/Act LED
Table 1-10 describes the Link/Act LED on the chassis in different states.
Table 1-10 Meanings of interface LEDs in different states
LED Meaning
Link On (yellow) Indicates a link has been established.
Link Off Indicates the link is not established.
Act On (yellow) Indicates the ADS device is transmitting or receiving data.