5
14.
Replace the reverse light bulb, and then re-install the light socket. Secure all the wires
with cable ties or electrical tape.
15.
Re-attach the negative battery cable to the battery.
Monitor Installation
When choosing a location to mount the monitor, make sure the
monitor is in an area that will not obstruct your vision while driving.
1.
Before mounting the monitor, clean the mounting surface well.
2.
Position the suction mount to the smooth surface which suits your
requirement.
3.
Press the suction cap against the smooth surface and press the
lock down to attach and fix the mount to the surface.
Snap in the monitor to the suction mount.
4.
Adjust the mounting arms to suit your view angle to the monitor and tighten the screws
on the mount to fix the position.
5.
Route the power cable to the vehicle’s cigarette lighter socket 12V/24V power outlet.
The cable must not interfere with the safe operation of the vehicle.
6.
Insert the small 12V/24V DC plug of the power cable into the right side of the monitor.
7.
Plug the 12V/24V cigarette lighter plug into the vehicle’s cigarette lighter socket.
To maximize the effectiveness of the suction mount, it is recommended that the application
be performed under the following conditions:
Surface temperature should be between 21 and 38 degrees Celsius.
Application below 10 degrees should be avoided.
Application should not occur in direct sunlight.
Mounting should be protected from exposure to direct sunlight for a period of 24 hours.
NOTE
: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN IMAGE MAY TAKE A
FEW SECONDS TO STABLIZE. PLEASE WAIT UNTIL THE IMAGE HAS STABLIZED BEFORE
BACKING UP.
System testing
1.
Reattach the vehicle’s negative battery cable.
2.
Turn the ignition key to the accessory position, do not start the vehicle.
3.
Engage the parking brake, and then put the shifter in the reverse position.
4.
After testing the unit and you are satisfied with the route you have chosen for the
cabling, you must permanently install it.
5.
Route all wires behind interior panels or under carpeting so they are hidden. Use
supplied cable ties to neatly gather any excess wire.
