NRI G-13.mft MDB/S1, Operating Instructions Manual

Page: 26 / 65

S
TARTING UP
G-13.mft MDB/S1
26
National Rejectors, Inc. GmbH, Buxtehude
Starting up in the vending machine
Install the MDB model of the G-13.mft in vending machines with an MDB
interface and the S1 model in vending machines with an appropriate S1
interface:
1
If necessary, install the sorting device on the coin validator (see
section "Installation of the NRI sorting device ..." in this chapter).
2
Disconnect the machine from the mains supply.
3
Hang the coin validator in the vending machine mount using the late-
ral mounting studs
1 (see Fig. 3).
4
Connect the coin validator to the machine using the 10-pole interface 3
provided and the appropriate connecting cable (see Fig. 3).
5
Reconnect the mains supply to the machine.
Make sure the correct supply voltage is connected (see label).
The G-13.mft as an MDB model does not fulfil the MDB specification
on two counts, i.e. the specified voltage range and the electrical
isolation of the communication lines.
If a supply voltage of 42 V max. and electrical isolation are
desirable, an MDB converter G-55.0360 can be ordered from NRI
(ordering code 23627).
1
3
2
1 Mounting studs
(not illustrated on the left-hand side of the device)
2 Interface –
PC programming station (WinEMP)/
Palm handheld (PalmEMP2)
3 Interface – vending machine
1
1
Fig. 3: Installation