12
National Rejectors, Inc. GmbH, Buxtehude
S
AFETY
INSTRUCTIONS
Protecting yourself and equipment
The hopper may only be connected by a qualified electrician.
Only use the hopper according to proper use. Under no
circumstances can the manufacturer be held liable for any
damage or loss resulting from improper use of the device.
The hopper is not suited for outdoor use. For this it must be
protected using a housing/machine with an appropriate
protection class.
The hopper PCB is fitted with components that can be
damaged by electrostatic discharge. Please observe the
handling instructions for components exposed to the risk of
electrostatic discharge.
Do not use the hopper, if the device or connecting cable are
demaged.
Select the correct voltage for the hopper (see label) and
protect the device against overheat demage caused by e.g.
short-circuit or overload by means of a 3A-fuse (according to
IEC 127).
Never pull the connecting cable of the hopper from the
machine when a voltage is applied.
Pull out the machine’s mains plug before you install, clean or
remove the hopper.
Contact NRI if you wish to alter the construction of the device
to a greater extent than that described in these instructions.
Keep water and other liquids away from the hopper.
If the device is no longer required, please dispose of it
correctly.
We reserve the right to make technical modifications to the
device which are not covered by these instructions!