EN 16
Illumination
To activate the lights press button
④
. The lights
will switch on at full power.
Lighting can be activated independently from the
motor.
Maintenance
Grease filter
The cooker hood contains 2 metal grease filters.
Grease filter indication:
--------------------------------------------------------
Indication: 4 flashing speed indicator lights
--------------------------------------------------------
After 20 cooking hours, the 4speed indicator lights
will start to blink during 5 minutes, this indicates
that the grease filter has to be cleaned. When
replacing the cleaned filter, you have to reset the
hood by pushing the – button during 5 seconds .
If you don’t reset, the speed indicator lights will
continu blinking.We advise you to clean your filter
twice a month for an optimal operation.
Access to the filter
Open the plate by pulling at the same time at
the right and left set. Pull the plate towards you.
When completely opened, the plate will stand on
itself. You can now access the grease filters.
The little gutter (A) must be cleaned after each
usage
Cleaning the filter:
- in the dishwasher
- manually: in a hot solution of water and a liquid
detergent. Rinse and allow to dry completely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Important! Always place the upper grease filter
with the handle downwards and the lower grease
filter wit the handle upwards.
You can close the hood by pushing the middle
part of the hinge upwards (1). Always support the
plate (2)
Recirculation
Cleaning indication:
--------------------------------------------------------
Indication: red speed indicator lights up
--------------------------------------------------------
The red speed indicator light will light up after 200
working hours (time to regenerate the Monoblock
recirculation filter). The recirculation filter is to be
found behind the grease filter.
Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found in
its opening in the cooker hood. Remove it from
the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. In this case it is best to im-
mediately regenerate the filter in the oven.
Reset the Monoblock recirculation filter:
The cooker hood (motor) must be running!
Simultaneously press + and – for 5 sec. until
the red indicator lamp flashes 3 times for
confirmation. If the programming is not carried
out, the programming is automatically set after
the chimney hood has been switched on 10 times.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.
