NVR-5404POE User’s manual (Short) ver.1.1
All rights reserved © AAT Holding sp. z o.o.
7
STARTING THE DEVICE
Install the top cover on the NVR and screw it back.
2.3. Connecting power adapter.
Please connect provided DC 48V adaptor in the rear power port of the NVR like depicted below.
To start the unit turn on the power switch on back panel. Initialization lasts for approximately 60
seconds. During this time executing any device functions and pressing any buttons is prohibited. To
shut down the device please use the menu.
CAUTION:
Make connection when the power is not applied to the 48V DC power adapter.
Do not place the power cord under the carpet or rug. The power cord is usually earth-grounded.
However, even if it's not earth-grounded, never modify it on your own for earth-grounding.
Make sure that power adapter is placed near of NVR and secured from accidental disconnection.
CAUTION:
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
may cause short-circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
48V DC ADAPTER
POWER SWITCH
