NVIP- NVRA0104/GO and NVIP- NVRA0208/GO User’s manual(Short) ver.1.0
All rights reserved © AAT Holding sp. z o.o.
10
2.3. Power connection.
Two adaptors are provided: one for NVR operation (DC 12V), and the other for PoE (Power Over
Ethernet, 48V).
•
NVR power connection -plug the provided DC 12V adaptor in the rear power port of the NVR.
•
PoE Switching hub power connection - plug the provided DC 48V adaptor in the rear power port
of the NVR.
When done, attach the adaptor cable clip to the rear panel and insert the cable in like depicted below.
Note:
Make connection when the power is not applied yet.
Do not place the power cord under the carpet or rug. The power cord is usually earth-
grounded. However, even if it's not earth-grounded, do never modify it on your own for earth-
grounding.
For stable power supply, this product provides two separate adaptors and two corresponding
AC cords by factory default. Make sure all cables are connected properly.
To start the unit turn on the power switch on back panel. Initialization lasts for approximately 60
seconds. During this time executing any device functions and pressing any buttons is prohibited. To
shut down the device please use the menu.
2.4. Connecting camera.
You can connect a PoE-featuring IP camera to the rear [CAM1]~[CAM8], RJ45 port using the CAT5
10/100Mb Ethernet cable without a separate power source. The Ethernet connection is effective within
100 meter in distance.
STARTING THE DEVICE
