NVIP-3C7000D-P, NVIP-5C7000D-P User’s manual(short form) ver.1.0
All rights reserved © AAT Holding sp. z o.o.
12
2.3. Starting the IP camera
To run NOVUS IP camera you have to connect ethernet cable between camera and network switch
with PoE support (IEEE 802.3af).
After connecting power supply green LED should light on. Initialization process is then started which
takes about 30 seconds. You can then proceed to connect to the camera via web browser.
If the connection is successfully established, orange LED blinks with a frequency proportional to the
quantity of data sent. Connecting via web browser is then possible. If
connection isn’t established (the
network cable is disconnected) green and orange LEDs aren't active, solid light means that network
connection is ok but camera doesn't receive or send any data, with possible PC network settings error.
The recommended way to start an IP camera and perform its configuration is a connection directly
to the network switch which is not connected to other devices. To obtain further information about
network configuration parameters (IP address, gateway, network mask, etc.) please contact your
network administrator.
Connection utilizing network switch with PoE support
Caution:
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
.
Computer
IP Camera
Power supply and
network transmission
Network transmission
Network Switch
PoE
START-UP AND INITIAL CAMERA CONFIGURATION
