NVIP –2DN3000C-1P- User’s manual (short form) ver 1.0.
All rights reserved © AAT Holding S.A.
15
ELECTRIC CONNECTORS AND ACCESORIES
5. ELECTRIC CONNECTORS AND ACCESORIES
5.1. Connecting power supply to the camera.
Camera can be supplied using external power supply unit corresponding with the
camera parameters or by using RJ45 network socket and PoE (802.3at Type 1 )
power supply unit. If you’re using external power supply pleas connect wires
according to polarisation shown on picture:
Information:
Power supply adapter is not included. Please use power adapter with parameters specified in user’s
manual.
Caution:
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
5.2. Camera control - RS-485
By using the RS485 interface can control an external camera PTZ domes. For this purpose, use the RS-
485 port on the rear of the camera. On the Settings tab PTZ Protocol should select communication
protocol (recommended Pelco-D, Pelco-P), address and transmission speed (recommended speed
9600bps).
5.3. Connecting alarm inputs/outputs.
Alarm input
Alarm input connection
Alarm
input (-)
Alarm GND
IP Camera
Alarm
input (+)
Alarm IN
Switch/sensor
IP
Camera
PTZ
Pommel
RS-485
+
-
+
-
~
24
VAC
~
+
-
DC 12V