Novus DigiRail Connect DMIX DO ETH, Instruction Manual, Page: 13 / 34

NOVUS AUTOMATION 13/34
5.3.2 CONNECTIONS OF ANALOG OUTPUTS
Fig. 20 – 0-60 mV / 0-10 V Fig. 21 – 0-20 V / 4-20 mA
5.4 DIGITAL OUTPUTS
DigiRail Connect has versions with 8 channels of transistor-sourcing digital output, identified as K1 ... K8 , and with 4 channels of relay-type digital
outputs, identified as R1 ... R4 , on its front panel.
Each channel can be configured through the NXperience configurator software (see the Configuration Software chapter).
Fig. 22 – Digital Outputs
The following parameters define the operation of the digital outputs (see section Digital Outputs in the Configuration Software chapter):
• Actuation Mode: Allows you to define the mode of operation of the digital output.
o Logical State: When selected, it allows the value 0 or 1 to be applied to the configured digital output.
o Pulse: When selected, allows the digital output to be turned on for a set time (defined in the Pulse Duration parameter) and after that pe-
riod returns to the off condition.

Pulse Duration: Allows you to set the pulse duration and how long the digital output will remain on.
o
Pulse Train: When selected, it allows the digital output to generate a defined pulse sequence.

Pulse Duration: Allows you to set the pulse duration and how long the digital output will remain on.

Repetition Period: Allows you to define the repetition period of the pulse train, which consists of the interval between the pulses.

Number of Pulses: Allows you to set the number of pulses to be applied in the configured range.
•
Power On State: Allows you to set the initial state of the device's analog output after initializing the device until a command is acknowledged.
o
Off: Allows the digital output to remain off (0) after device initialization.
o
On: Allows the digital output to start on (1) after device initialization.
o
Last Valid State: Allows the digital output to adopt the last valid state registered.
•
Safe State Watchdog: Allows you to set the condition to be adopted by the digital output when a command is interrupted due to a communica-
tion failure.
o Off: Allows the digital output to remain off until communication is restored.
o On: Allows the digital output to remain on until communication is restored.
5.4.1 FLAGS K1 ... K8 / R1 ... R4
The flags K1 ... K8 and R1 ... R4 , when lit, indicate that the respective channel is enabled (logic state 1 ).