37
Installation
N-563 S
Disengage the carriage
During the proceeding work, it may be necessary to disengage the carriage from the connector attachment.
This can be done without the need to disconnect the linking bar.
1.
To move the garage door, manually pull on the pull cord (I) on the
carriage.
2.
Disconnect the carriage from the toothed belt or the chain.
3.
The garage door can now be moved manually.
4.
To operate the gate manually for a longer period of time, you can
insert the locking pin (II) into the carriage (III) in the bore provided
for this purpose. To restore normal operation, loosen the locking
pin (II).
II
III
I
Connect the garage door operator to electrical power and controls
Warning high voltage:
• Pull out the main plug from the mains socket before you open the cover of the drive head.
• Do not connect any live leads. Only connect potential-free buttons and potential-free relay
outputs.
• After connecting all cables, connect the cover to the drive head again.
Warning:
Before using the operator for the fi rst time, it must be tested to make sure that it is working properly
and safely (see section on Maintenance/Checks).
Warning:
Danger by optical radiation!
If you look at an LED for an extended period from a short distance, this can cause optical binding.
Sight is then severely restricted for a short time. This can result in serious or fatal injuries.
You must not look directly at an LED.
E F G H I
P
J
N M
L K
Summary of Contents for N-563 S
Page 1: ...N 563 S WN 933001 02 6 50 05 2019...
Page 142: ...142 N 563 S...
Page 143: ...143 N 563 S...
Page 144: ...TORMATIC Eisenh ttenweg 6 44145 Dortmund www tormatic de...
