Novexx Solutions ALX 92x, Service Manual

Page: 82 / 824

04/16 Rev. 06 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
7
Settings in the parameter menu

Further settings for 64-xx Dispenser see user manual 64-xx, topic section „Setup“,
chapter Settings at 64-xx dispensers

on page 17.

Settings for application of ALX 92x with applicator see service manual ALX 92x,
topic section „Applicator Interface“, chapter
Selecting an applicator type

on page 5.
Setting Interface Printer Parameter Value
Accept start si-
gnals
-- All
SYSTEM PARAMETER > Exter-
nal signal
Singlestart
Signal source
Singlestart
input
64-xx --
a
--
64-xx Dispenser,
AP 5.4 Dispenser,
AP 5.6 Dispenser
DISPENSER PARA > Start
source
Foot switch
AP 5.4, AP 5.6, AP 7.t -- --
Disp. edge
light barrier
64-xx Dispenser,
AP 5.4Dispenser,
AP 5.6 Dispenser
DISPENSER PARA > Start
source
Light barrier
USI
64-xx Dispenser
DISPENSER PARA > Start
source
USI interface
64-xx, ALX 92x, ALX 73x -- --
I/O AP 5.4, AP 5.6, AP 7.t -- --
AI ALX 92x, ALX 73x -- --
Signal flange
Singlestart
input 64-xx, AP 5.4, AP 7.t,
AP 5.4Gen II, AP 5.6
SYSTEM PARAMETER > Start
print mode
„Pulse rising“
USI 64-xx, ALX 92x
DP INTERFACE > Start print
mode
„Pulse rising“
I/O AP 5.4, AP 5.6, AP 7.t
I/O BOARD >
Start print mode
„Pulse rising“
AI ALX 92x, ALX 73x
APPLICATOR PARA > Start
print mode
„Pulse rising“
Start delay
Singlestart
input AP 5.4Gen II Dispenser,
AP 5.6 Dispenser DISPENSER PARA > Start off-
set
Enter distance
between start
sensor and dis-
pensing edge
USI 64-xx, ALX 92x, ALX 73x DP INTERFACE > Start delay
I/O
AP 5.4Gen II Dispenser,
AP 5.6 Dispenser
DISPENSER PARA > Start off-
set
AI ALX 92x, ALX 73x
APPLICATOR PARA > Start de-
lay
[Tab. 5] Overview on the most important settings for start signal application (Firmware versions 3.52/6.52/7.52).
a) „--“ = No setting required.