NOVAWINCH FENIX 25, Instructions And Operator’S Manual

Page: 6 / 22

Page 4
3
.
Ensure the solenoid location selected provides sufficient clearance form all metal
structures,such as frame tubes.
A.+ ,YELLOW wire #1 terminal
to motor positive “+”
B.- ,BLUE wire #2 to terminal
motor nagtive “-”
C. ,RDE wire to circute terminal
breaker unmarked side.
D. ,BLACK wire,to terminal
Battey Negative (-) Terminal.
E.Center spade connector,connects
the small black jumper wire,only,
(assembled as shown).
F.outer left spade
connector
,
GREEN wires
.
G.outer right spade
connetor
,
BLACK wires
.
(Top of Solenoid)
TOGGLE SWITCH INSTALLATION
CAUTION
!
When attaching wires to the motor or solenoid terminals, hold the
inner nut with a wrench while tightening the outer nut with a second
wrench. Do not allow the terminals to rotate in their housings. Rotation may cause
internal wire breakage or part misalignment ( Fig 4).
Fig. 4 - Proper Terminal Tightening
Step ( 1 )
Check to ensure that the vehicle ground and positive leads from the battery are
disconnected before performing any electrical work.
Wire Rope
Hook
Hand saver
Roller fairlead
Mounting plate
Solenoid
The thumb switch
The triangle plug
Cable set
Remote control
"Circiut breaker"
Circiut breaker cover
Screws and nuts
1
1
1
1
1
1
1
1
1
1
1
1
1
35
36
37
38
39
40
41
42
43
44
45
46
47
Wire Rope
Mounting plate
Roller fairlead
Solenoid
The thumb switch
The triangle plug
cables
Remote control
Hardware set
Circiut breaker
Page 37