NOTE : Because the Super Bass Station’s program numbers start at “000” the next higher
number must be used via MIDI program change to call up the correct sound. i.e. 019 on the
Super Bass Station = MIDI program change 20.
MODE 2 - MIDI Receive Channel
This is where you set the MIDI receive channel for the Super Bass Station . Use the “Mode” button to select the “MIDI RX
Ch.” mode - LED on, and then the “Data Entry” keypad to enter your selection. The recognised numbers in this mode are
from “01” to “16”. NOTE: the “MIDI RX CH.” LED will flash when MIDI data is received on this channel.
MODE 3 - MIDI Transmit Channel
This is where you set the MIDI transmit channel for the Super Bass Station . Use the “Mode” button to select the “MIDI TX
Ch.” mode - LED on, and then the “Data Entry” keypad to enter your selection. The recognised numbers in this mode are
from “01” to “16”. NOTE: The MIDI TX and RX channel settings are memorised when the power is turned off.
MODE 4 - Utility
This is the section were Global and some Sound Parameters are edited.
The various Parameter groups are selected by pressing the appropriate button on the twelve key pad when in the utilities
mode. Pages exist within these Buttons and they are selected by pressing the appropriate button again. Once the desired
page is selected the ident flashes between the ident of the parameter selected and it’s value. To change the value of any
parameter use the “Data Entry / Portamento” Rotary control. Fine increments of parameters values can be set using the
“-” and the “+” Buttons.
Data Entry/Program
MIDI/Utilities
23
