RELAY7 User Manual v3
15
Chapter 2
RELAY7 Installation
Use the following steps to first route the cables, connect the RELAY7 to the SMART7 and power
up.
2.1 RELAY7 Cable Routing to SMART7
If using the optional Ethernet cable (SMART7-I NovAtel 01020095), the cable must be inserted
through the RELAY7 and then connected to the SMART7 before physically attaching the RELAY7 to
the SMART7-I. After the cables are inserted and cables connected, the cable can be routed on
the underside of the RELAY7.
The Ampseal interface connector is permanently attached to the RELAY7 and must be connected
to the SMART7 by pushing firmly onto the SMART7 Ampseal connector.
Refer to
Ethernet Cable for SMART7-I (01020095)
on page 39 for cable details.