DC POWER CABLES
PAGE
|
56
The figure below illustrates how ’s outputs can drive the DC Input Module of a Programmable Logic
Controller (PLC). By supplying voltage (+VDC) to Pin 13, Output Common, each output is independently
switched to activate individual PLC inputs.
Figure 3-20 output driving PLC input module.
DC power cables
The DC power cables shipped with the p100/150 lasers are manufactured with 6 AWG wire to a standard
length of 1.8 m (6.0 ft). Diameter 0.162 in requires a minimum bend radius of 1.944 in. Terminals on the
laser end of the cables fit the laser’s M6 studs while terminals on the power supply ends are sized to fit
M6 (0.25") bolts.
When using a power supply other than the PS-48-4000, you can fabricate your own DC voltage sense
cable, or you can remove the 26-pin HD D-subminiature connector and terminate the sense cable to
match your power supply’s DC voltage sense connections. Please refer to the power source manual for
details.
Important Note: If you lengthen the DC Power Cables shipped with the p100/150 laser, you must
calculate and measure the additional voltage drop to ensure that 48.0 VDC is available at the
laser’s +48V POWER terminal under full-load conditions. Keep in mind, depending on the additional
length required, you may need to use larger gauge (2/0) wire.
Summary of Contents for SYNRAD Pulstar p100
