NovaLynx Corporation________________________________________________________________________________
200-WS-21-A
Page 6
November 2018
4.1
Power Supply Connection
The 200-WS-21P power supply (sold separately) is provided with
¼" spade connectors that fit the terminals at the lower left corner
of the Wind Alarm circuit board. If you are using a different power
supply, use the provided accessory connectors to wire to your 12V
ac or dc power source. Plug the AC Adapter into a wall outlet and
check that the green power LED on the Wind Alarm circuit board
turns on.
The display should look similar to the
illustration on the right. This is the
operating mode screen.
NOTE: If you see the word "Temp:"
instead of "Wind:" then the DIP
switches are in the wrong position.
Refer to the "DIP Switch Settings"
section of the manual to correct this
situation.
4.2
Menu Navigation
Locate the programming buttons below the display.
4.2.1
MENU Button
Press the MENU button. One of the three menus will be displayed (depending on which was viewed
last). Additional uses of the MENU button will be discussed in the following programming section.
4.2.2
UP and DOWN Buttons
Use the UP and DOWN buttons to cycle through the menus.
1.
Alarm Delays – the delay (seconds) before and after
an alarm threshold is crossed.
2.
Wind Alarms
– the set points at which the alarm
occurs.
3.
Max Wind Speed – displays the maximum wind speed
recorded since the last time the CLEAR button was
pressed.
MENU UP
DOWN CLEAR GO
ACin / DCin
ACin/DCgnd
200-WS-21P
AC Adapter
(sold separately)
(DC+)
(DC-)
Max Wind Speed
0.0 (mph)
Wind Alarms(mph)
1: 15 2: 15
Alarm Delays (s)
ON:15 OFF:15
UP
DOWN
UP
DOWN
A/DM
Menu
Up
Dn
Clr
Go
PROGRAMMING
BUTTONS
POWER LED
Wind: 0.0 (mph)
1: 15 2: 15
