(348) ANBAU 0000-GB
attaching tO tractOr
GB
- 7 -
Adjusting lower links
• The drive shaft (GW) position should be approximately horizontal
when mowing.
- Set the tractor's lifting gear accordingly (H1)
- Set the tractor hydraulics (ST) using the bit stop.
This height allows optimal evenness when working on uneven ground
and need not be changed for swinging cutter bar up.
- Connect hydraulic snap coupling for swivel cylinder.
Important recommendation!
A transfer, which is located near the gear, advises which p.t.o. speed
your mower unit is equipped for.
Standard: Gear for power take-off 1000 rpm.
Optional exra: Gear for power take-off 500 rpm.
Order number: spare part book
Fitting drive shaft
- Before operating for the first time, drive shaft is to be checked and
adapted if necessary. See alse chapter "Drive Shaft" in supplement
B.
Parking in the open
When parking for longer periods in the open, clean plunger rods and
then coat with grease.
h1
Gw
TD 4-00-1
1000 rpm
540 rpm
TD 18/96/2
Standard (540 rpm)
Standard (540 rpm)
FeTT
