Norwood Kwik-Till HSD2500, Operator'S Manual

Page: 103 / 154

5 - MAINTENANCE
5-11
DAILY
Checking / Adjusting Scraper Alignment
1. Fully extend the scraper hydraulic cylinders.
(See Fig. #
5-16)
Fig. # 5-16 Fully Extend Scraper Hydraulic Cylinders
2. With the hydraulic cylinders fully extended, check the gap
between the scraper plates and the tire valley’s. Desired
Gap is 3/8”. (See Fig. # 5-17) ( Note: Shank is removed
for illustrative purposes)
3/8” Gap
Fig. # 5-17 Check Gap
3. Check to see if the Shank Scraper Assemblies A are
centered in the valley of the Rubber Tires B .
(See Fig.
# 5-18)
B
B
A
Fig. # 5-18 Center Scraper Assemblies
4. If the shank scraper assemblies are not centered, loosen
the 1/2-13 X 1-1/2 Bolts A securing the Scraper Base
Pivot Weldments B . Adjust left or right until centered.
(See Fig. # 5-19)
Fig. # 5-19 Adjusting Alignment
B
A
A