Copyright © 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1037-020 Rev 3 11/20
12
D6001DE-L Double Unit Series (Double Egress)
Power Operator
B. Install Arm Assembly To Track.
1 . Open right door .
2 . Using an adjustable wrench, rotate
top pinion 45 degrees toward door
hinge . You will feel resistance from
spring . (Figure 27)
3. While holding pinion at 45 degrees
,
slide arm on bottom pinion parallel
to frame as shown . (Figure 27)
NOTE: Pinion flat should be aligned
as shown. (Figure 28)
4 . Secure arm to pinion with 1/4-20 x
1/2" screw and countersunk patch
washer . (Figure 27)
5 . Insert stud on arm into slider in track
by pressing clip on backside of slider
onto stud . (Figure 29)
6 .
To adjust track stop:
• Use allen wrench to loosen set
screw in bumper stop .
• Open door to full open position .
• Slide bumper stop until it just
touches end of slider .
• Tighten set screw in bumper stop
so bumper will stay in position .
(Figure 30)
A. Mount Track.
1 . Using previously prepared holes in
left door, install three (3) 1/4-20 x
1-5/8" screws through track and into
sex bolts . (Figure 25)
NOTE: (Figure 26)
• Opening of track is toward top
of door.
• Adjustable bumper stop is toward
hinge edge of door.
Install Track and Arm to Right Door
Adjustable Bumper Stop
Track Opening
Figure 25
Figure 26
Figure 27
Figure 28
Figure 30
Figure 29
