Norton Clipper C914P, Owner'S Manual

Page: 13 / 48

13
Blade Attachment Components
4. Remove the blade shaft nut, (Turn clockwise)
,
and remove the outside
collar.
NOTE:
The Blade Shaft has a flat for use with a 19mm wrench
to prevent rotation.
5. Clean off any foreign particles on the clamping surfaces of both collars and
on the mounting surface of the blade.
6. Place the blade on the blade shaft, lining up the drive pin hole in the blade
with the drive pinhole in the inside collar. The C914P will only accept
Diamond Blades with a Maximum Diameter of 14” (350mm) and a Bore of
1” (25.4mm) and a maximum core thickness of 1/8” (3.1mm) see
Figure:
Blade Installation for details.
NOTE:
Maximum 14” (350mm) Blade can be
used with the C914P, if the blade does not fit under the Blade Guard then
the diameter is greater than 14” (350mm). ALL Diamond Blades have a
direction of rotation indicated on the blade either, install the blade so that
the direction of rotation is clock wise. Use only Norton Diamond Blades
Loose Collar
Blade Shaft Nut
Left Hand Thread
Blade Shaft
Blade Guard
Tight Collar