05278B-2
12
OWNER’S MANUAL#
39202
ver.
05278B-2
PAGE # 12 English Version
Channel Scan (Manual Scan)
If the existing channel becomes noisy or
starts having interference, press the
Channel (CH) button on the handset.
The Excursion
®
39202 will automatically
scan for the best channel available.
NOTE:
It takes about 2 seconds for the
unit to scan to the next clear channel.
Memory Dialing
You can store and recall up to 10
frequently called telephone numbers in
memory(up to 22 digits).
Storing Telephone Numbers into
Memory
1.
Ensure that the handset is in
standby (the phone is hung up).
2.
Press the MEMORY button on the
handset.
3.
Enter the phone number to be stored
into memory.
4.
Press the MEMORY button again.
5.
Press the desired one-digit memory
location (from 0 to 9).
6.
To store more phone numbers or
modify existing numbers in memory,
repeat steps 1-6.
NOTE
: Refer to the Pause Function
section for storing pauses.
Dialing a Number Stored from
1.
Pick up the handset and press the
TALK button.
2.
Press the MEMORY button.
3.
Press the desired one-digit memory
location (from 0 to 9).
NOTE:
If you have difficulty storing or
recalling numbers from memory, refer to
the “Troubleshooting” chart of this user
manual.
Changing Stored Phone Numbers
•
Follow the steps described in
“Storing Telephone Numbers into
•
The new phone number will
automatically replace the previous
one.
Pause Function
If you need a pause in the memory
dialing sequence, you can store a four-
second pause in the number you are
storing into memory. To insert a pause,
press the RE/PA button once for a 4
second pause while storing a phone
number into memory. For longer pauses,
press the RE/PA button a few more
times.
Mute
When the MUTE button is held down
during a phone conversation, you will
hear the caller, but the caller will not hear
you.
1.
Press and hold the MUTE button to
temporarily disable the handset
microphone.
2.
Relase the MUTE button to enable
the handset microphone.
Page
This feature allows you to locate the
handset when it is not on the base,
should it be misplaced or lost.
1.
Press the PAGE button on the base
unit. The IN USE LED indicator on
both units will flash.
2.
The handset will start beeping to
allow you locate the handset.
Low Battery Warning
•
When the handset battery voltage
level is low, the handset will beep
twice every 1 minute and the
handset IN USE LED indicator
will flash.
•
The call will be disconnected after
about 4 minutes. Return the
handset to its cradle on the base
to rechanrge.