- Reorient or relocate the receiving antenna.
- Increase the space between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer, an experienced radio, or a TV technician for help.
- Only a shielded interface cable should be used.
Finally, any changes or modifications to the equipment by the user not expressly approved by the grantee or
manufacturer could void the user's authority to operate such equipment.
DOC COMPLIANCE NOTICE
This digital apparatus does not exceed the Class A limit for radio noise emissions from digital apparatus set out in the
radio interference regulation of Canadian Department of Communications.
CE COMPLIANCE
This monitor complies with the basic protection requirements of the Electromagnetic Compatibility (EMC) Directive
2004/108/EC for electrical and electronic equipment imported into the European Union (EU):
The electromagnetic disturbance generated by the apparatus does not exceed the level specified in the harmonized
EMC Standards for this type of apparatus. It has a level of immunity to the electromagnetic disturbance to be expected in
its intended use, and should operate without unacceptable degradation of its specified performance.
Back View of Monitor
Connector Panel is located on the underside of the case rear
projection, just above the stand
Use ONLY a properly grounded three wire cord appropriate for the
local power system.
Connections
HDMI
BNC 2
OUT
BNC 2
IN
BNC 1
IN
AUDIO
OUT
AUDIO
IN
AC IN
VGA
Summary of Contents for NTH-LED18
Page 11: ......