Initial Set-up
7
WARNING
Carefully read and follow all instructions for initial assembly and set-up of
this log splitter.
Failure to properly assemble and set up this equipment could result in serious
injury to the user or bystanders, or cause equipment damage.
Step One:
Assemble log splitter
Assemble your log splitter.
See the “Assembly” section of this manual – It will provide you with detailed instructions
on:
•
Inspecting shipped components and whom to contact if anything is missing or
damaged.
•
Assembly.
•
Testing.
Step Two:
Add oil to engine
Add oil to engine.
Using a funnel, add SAE 10W-30 oil up to the FULL mark on the dipstick. (See
engine Owner’s Manual for oil capacity and location of fill cap.)
Step Three:
Add Hydraulic Oil to
Reservoir
1. Remove hydraulic oil dipstick.
2. Refer to the
Specifications
section for approximate hydraulic oil capacity.
3. Fill reservoir with 10 wt AW32, ASLE H-150, or ISO 32 oil. Use a funnel
4. Replace hydraulic oil dipstick and check that oil level reads full.
5. Start engine and use split control lever to extend and retract wedge 5 (five) times
to remove air from the high pressure lines.
6. With wedge retracted, check oil level again. Fill if necessary.
Note:
If the log splitter will be run for long periods of time in outdoor temperatures above
70
°
F, we recommend changing the hydraulic oil to DEXTRON III.
Step Four:
Check Hydraulic
system
Check the hydraulic system carefully:
1. Visually inspect all hoses, tubing, clamps/fittings, pump, and cylinder for cracks,
fraying, kinks, or other damage.
2. Check all components for oily residue, which may indicate a leak.
Do NOT operate the log splitter if there is any indication of damage or oily residue.
Small leaks in hydraulic lines can cause severe injuries and can also be an indication of
catastrophic failure in the near future. The life of hydraulic hoses may be from a few
months to a few years, depending on use and storage patterns.
WARNING
: High fluid pressures and temperatures are developed in hydraulic
log splitters. Hydraulic fluid escaping through a pin hole sized opening can burn or
puncture skin, resulting in wounds that could cause blood poisoning, infection,
disability, gangrene, amputation, or death. Therefore, the following instructions
should be heeded at all times when inspecting or servicing the hydraulic
components of the log splitter:
•
Stop the engine, disconnect the spark plug, and move the split control lever
back and forth to relieve pressure before changing or adjusting hydraulic
system components such as hoses, tubing, fittings or other components.
