Splitting Operation
19
7. Important
STUCK LOG
procedure
If a log does not split completely and becomes stuck on the wedge, follow the
instructions below to remove the log.
A log can become stuck to the wedge if the wedge becomes embedded in the log and the
log doesn’t split and separate. This can happen if the log is too stringy or tough to split
completely.
If this happens, follow the directions below.
WARNING: NEVER
attempt to remove a stuck log by:
• Using the hydraulic force of the splitter
• Modifying the splitter
• Adding attachments to the splitter
Personal injury could result from log or metal pieces flying out at high speed toward
the operator or bystanders, or the splitter could become damaged.
1.
Remove pressure from log by moving wedge away from the endplate.
2.
Turn engine OFF.
3.
Remove stuck log from the wedge
manually
with a pry bar or a sledgehammer.
Important: Be extremely careful as log pieces may fly off as they separate
from the wedge. Make sure bystanders are clear and wear safety goggles.
4. Do not attempt to resplit a stuck log once it has been removed from the wedge.
Manually split with an axe or cut with a chainsaw.
8. Remove split
wood
Move each log away from log splitter after it is split.
Split logs left near the log
splitter are a trip hazard.
9. After use
1. Turn off engine.
2. Remove engine debris.
Debris on a hot engine can be a fire hazard. After the engine is off, clean debris and
chaff from engine cylinder head, cylinder head fins, blower housing rotating screen,
and muffler areas.
WARNING:
Avoid contact with hot muffler.
Any Questions, Comments, Problems or Parts Orders
Call Product Support 1-866-443-2576
