Northern Telecom Unity I, User Manual

Page: 6 / 7

E WAITING
UNITY I features (page plus
Tone
Your
comes equipped with a
pleasant sounding tone A
switch (on the base) allows you to set
volume level fo
Visual
The light in the plastic faceplate
of the flash when your
phone rings
Message
A lamp provides indiiafion of a message
waiting. Message waiting can be
provided in PBX applications where
message waiting Is a PBX feature.
Note:
There are fwo’versions of thls set
available; one with a neon lamp
operating on the main telephone the
other with a low-voltage Incandescent
lamp operating on the
TELADAPT jack In the case, there is
no visual ringing.
lone: Lift
the handset. there no
dial tone, check to make sure all plugs
property connected to
jacks
be or your line may be
out of order. contacting your
telephone suppliers, refer to Opemting
Problems section.
Call Out: If your phone can answer
but cannot call out, check with the
telephone company to verify if your
line accept signaling.
Ring:
Your Unity is designed for
standard “Straight Line-Bridged
Ringing”. Before calling the telephone
company, check make sure
is not in “off’. position. If your phone can
make calls, but fails fo ring for
calls, check with the telephone
company. It may be using unusual
ringing methods.
4
Switch: (For UNITY I and II
only.)
Thls fwo-position base-located
switch (Fig. I) should be to the
which corresponds to the
specific system In Le., P for PBX or C
for CO. For optimum performance of
your telephone check to ensure
poslfion and the application
CARE AND USE
your telephone In good
working order..
Since your telephone k an electrical
you should avoid
near a bathtub or in other wet
locations
Care should be taken during
pierced with sharp instruments
To malnfain the appearance of your
telephone avoid placing the
telephone in direct
Plastic surfaces of the phone and the
cord may be wiped clean using a soft
cloth dampened only with a mild
detergent solution.
Please Note:
telephone has been
wired for private line and should
be connected a party line.
Problems
If you should experience wlfh your
telephone service, take these required
steps prior to contacting the telephone
company.
1.
2
Unplug your telephone and any other
non-telephone company equlpmenf
you may own.
If the problem persists when only
telephone company equipment Is
connected, contact your local
telephone company to arrange for
repair.
if the problem is corrected by
non-telephone
company equipment, the
own. If you own more than one
telephone (or related telephone
products) reconnect them one at
a
time until the problem k isolated. The
problem telephone must be
and repaired before
Note:
Before calling the telephone
company for repairs, you should be
aware the telephone company
may charge for a service call when the
reason for the call is attributable to a
of the equipment you
own.
Charges
The telephone company may impose
various service charges or
provincial For example, a charge for
installation and a monthly fee for
maintenance of the required jack. A
monthlyfeemayakobe chargedforfhe
jack already installed. provided it k being
used as an extension telephone. It is
suggested that you contact your
telephone company prior to installation.