INSTALLING THE BURNER ASSEMBLIES
EQUIPMENT:
Two Right-Oriented Burner Assemblies, One Left-Oriented Burner Assembly, Six Large Quick Clamps, Allen Wrench
INSTALLING THE PROPANE LINES
EQUIPMENT:
Needle Valves, Propane Hoses, Propane Manifold, Velcro Straps, Crescent Wrench (not included)
1.
Attach the bottom (right-oriented) burner. Undo the nut of
two quick clamps. Insert the first clamp through the burner
support and the lowest holes on the center post, then secure.
Use the second clamp to attach the mounting bracket to the
center post.
2.
From the opposite direction as the first burner, secure the
middle (left-oriented) burner assembly to the center post.
STEP 1
3.
From the same direction as the bottom burner, secure the
remaining right-oriented burner assembly to the center post.
4.
Ensure the center post is straight and there is no wobble in the
legs. Adjust the feet on the base to straighten as necessary.
Ensure burner frames are level, then tighten the hex head
screws with the allen wrench.
STEP 1
STEP 2
STEP 3
1.
Install the needle valves. Thread a needle valve into the air
inlet tube on each burner. DO NOT OVERTIGHTEN. The brass tip
of the needle valve is soft and can snap off if overtightened.
Hand-tighten only.
2.
Attach the first propane hose. Thread the first hose into the
needle valve of the top burner. Tighten with a wrench.
3.
Run the propane hose along
the
front-facing
burner
support. Secure it to the
support with one velcro strap.
There should be as little slack
as possible without kinking
the hose. Attach two velcro
straps together and secure the
hose to the center post.
4.
Repeat Step 2 and 3 for the middle hose.
5.
Attach the bottom hose as described in Step 2. Use the final double
velcro strap to secure all three propane hoses to the bottom of the
center post.
6.
Install the manifold. Thread each propane hose into the
manifold and tighten with a wrench.
STEP 2
STEP 3
STEP 6
NOW YOU’RE READY TO BREW!
