BUILDING THE BASE
EQUIPMENT:
Base, Adjustable Feet, Legs, Small Quick Clamps, Assembled Base, Center Posts, One Large Quick Clamp
CREATING THE BURNER ASSEMBLIES
EQUIPMENT:
Burners, Burner Frames, Burner Supports, Hex-Head Screws
ASSEMBLY
BEFORE YOU BEGIN
Check your inventory. Ensure you’ve received everything listed in the Inventory section.
You can also follow along online with a how-to video for assembling the Center of Gravity™.
1.
Position the burner frame face-up.
2.
Remove the nut and washer from the screw at the
base of the burner.
FULLY ASSEMBLED
RIGHT-ORIENTED BURNER
3.
Holding the head of the burner, slide
the air inlet down through the center
of the frame. You will create two
right-oriented burners and one left-
oriented burner.
5.
For the left-oriented burner, position the air inlet tube through
the left notch in the frame. Use the right notch for the right-
oriented burners.
6.
Flip the burner over, holding it together as you flip it.
7.
Thread the washer and nut onto the burner screw.
Tighten with a wrench.
8.
Locate the holes on the
rim of the burner frame.
Use a hex head screw to
attach each support to
the inside of the frame.
4.
Insert the burner screw
through the hole in the
center bar on the burner
frame.
LEFT-ORIENTED BURNER
1.
Thread one foot into each of the four legs.
2.
Slide the non-footed end of the weldless leg over the bracket
on the base. Using two small quick clamps, secure each leg
to the base.
3.
Insert post, tapered end first, into the
base. Secure with a large quick clamp.
4.
Insert the two remaining posts. Do not
secure with quick clamps—this will be
done when the burner assemblies are
installed.
STEP 3
FULLY
ASSEMBLED
BASE
STEP 1
STEP 2
