User Manual for Patient Monitor
15
Chapter 4 Monitoring Screen
4.1 Main Screen
4.1.1 Date and Time Setup
Instead of entering into monitoring screen, it shows the date and time setting screen immediately after the
monitor is started, shown as Figure 4.1:
Figure 4.1 Date and Time Setup
The system will stay on this screen for 10 seconds. If you do not rotate the navigation knob within this
period, the screen will enter into the Main Screen.
Follow the steps below to set date and time.
Step 1
: Rotate Navigation Knob, move the gray cursor to “Edit”.
Step 2
: Press the knob, and then gray cursor stays on the Year of the date. Press the knob again and the
gray cursor becomes highlighted. Rotate the knob left or right to increase or decrease the year
value.
Step 3
: When the Year is set, press the knob to move the gray cursor to the Month of the date.
Step 4
: Repeat Step 2 and Step3 to adjust the Year, Month, Date, Hour and Minute.
Step 5
: If you have finished adjusting the date and time, press the knob and rotate the knob to move the
cursor
to “Save”, press it to save the settings. Then move the cursor to “Exit”, press it to exit the
date and time setting screen, meanwhile enter into the main screen shown in Figure 4.2.
The system is initialized and enters into Main Screen where monitoring and system operation are
performed. (shown in Figure 4.2)
