•
Install Hub Assembly to Axle.
Hubs come attached to the wheels.
Remove Dust Covers from Hubs. This
can be done by inserting a long bolt or
punch into the hole of the hub and
driving the dust cap off. A screwdriver
can also be used on the face side of the
Hub to gently pry the dust cover off. Be
careful to not drop the bearings or get
them dirty. Bearings are pre-lubricated.
After carefully sliding the Hub
Assembly and Wheel onto the threaded
end of the Axle, make sure that the
Bearings are slid into the Hub. Be
careful to not remove the grease from
the Bearings.
Place the two washers onto the axle flat
washer first. Align the flat surface of the
axle with the flat of the washers.
Tighten Axle nut to 35 ft-lbs. Loosen
the nut 2 notches of the crown nut.
Align a notch with the one of the tabs of
the tabbed washer. Using a screwdriver,
bend only one of the tabs of the tabbed
washer into the notch of the crown nut.
Replace dust covers by tapping gently
with a rubber mallet. Be careful to not
damage dust covers.
Note: It is the owner's responsibility to
re-pack and adjust the bearings within
the first 100 miles
Dust Cover
Axle Washers
and Bearing
FamilyGoKarts.com
