Page 12 of 33
3. Turn the Blade Pitch Handle counter-clockwise.
4. Continue to turn the Blade Pitch Handle counter-clockwise until
the Adjust Screw Nut is at the bottom.
(The Adjust Screw Nut is the silver piece in the bottom center of
the green piping in the picture at right. Also see Handle parts
diagram, item 19.)
5. Install the wire to the Yoke Arm (Handle parts diagram,
item 24) and tighten the nut.
Test the blade pitch by turning the Blade Pitch Handle and
observe the blades changing pitch (angle).
6. Take out the Engine Air Filter Cover and Air Filter Element.
7. Move the Throttle Lever on the handle fully counter-
clockwise (toward the screed).
Summary of Contents for 163cc
Page 22: ...Page 22 of 33 Parts Diagram Handle...
Page 24: ...Page 24 of 33 Blade...
Page 26: ...Page 26 of 33 Gear Box...
Page 28: ...Page 28 of 33 Safety Ring...
