North Atlantic Industries, Inc.
631.567.1100 / 631.567.1823 (fax)
6/12/2018
5330A Operations Manual Rev A6
110 Wilbur Place, Bohemia, NY 11716
Cage Code: 0VGU1
Page 11 of 24
The Remote Sense button can be “Enabled” or “Disabled”. The Remote Sense setting is applicable
only when the Local Sense is configured to the “Back”.
The Local Sense button can be configured for the “Front” or the “Back”. When the Local Sense is
configured for the “Front” the Remote Sense setting is ignored.
Remote Sense Setup
This screen allows for the remote sensing of each SIM channel and the reference supply.
Remote Sense Screen
Over Current
An “Over Current” occurs when either the reference or one of the SIM channels is overloaded. When an overload
is detected, the D/S will stop driving temporarily and will attempt to turn on every second for approximately 10
seconds, and if an over current is still present, the output will be disconnected and the corresponding tab will start
to blink red.
To reset this condition, once the cause of the over current has been resolved, press the tab that is blinking red
and the following “Over Current” screen will appear; press corresponding “Clear” button.
Over Current Screen
