Nortel R2MFC, Installation And Configuration Manual, Page: 39 / 114

Chapter 4 Installing the R2MFC MBM 39
R2MFC Media Bay Module Installation and Configuration Guide
Removing an R2MFC MBM from the BCM platform base chassis
Perform the following steps to remove an R2MFC MBM from the BCM platform base chassis.
Remove the R2MFC MBMs after the system is powered down.
1
Power-down the BCM system (see “Shutting down the system” on page 32 ).
2
Remove any cabling from the R2MFC MBM faceplate.
3
Grasp the right edge of the MBM ejector lever with your thumb, index, and middle fingers.
Pull outward to partially eject the R2MFC MBM. Pull further on the lever to eject the R2MFC
MBM from the bay.
Figure 11 on page 39 shows how to remove a BCM 200 R2MFC MBM.
Figure 12 on page 40 shows how to remove a BCM 400 R2MFC MBM.
4
Grasp the top and bottom edges of the R2MFC MBM. Remove the R2MFC MBM from the
BCM platform base chassis MBM bay (see
Figure 11 on page 39 and Figure 12 on page 40 ).
Place the R2MFC MBM in a clean, safe, and static-free area.
Figure 11 How to remove a BCM200 R2MFC MBM
Grasp the edge
of the R2MFC
MBM ejector lever and pull out.