Nortel Passport 2430, Installing And Operating Instructions

Page: 59 / 126

Installing Passport 2430 Components
308224-B Rev 00
2-11
5.
Push the WAN adapter module in until the connector pins align with the
base module connector socket in the Passport 2430 chassis.
6. Using a Phillips screwdriver, insert and tighten the screw (Figure 2-12) .
Figure 2-12. Securing the WAN Adapter Module to the Front Panel
7.
Remove the antistatic wrist strap.
8.
Connect the appropriate WAN cables to the new interface.
For cabling information, see the WAN module-specific Supplement (that came
with your WAN adapter module) and the Nortel Networks Cable Guide.
Where to Go Next
Use the following table to determine where you want to go next.
Note: See the WAN module-specific Supplement (that came with your WAN
adapter module) for information about the LEDs on the newly installed
module. The new module’s LEDs will not indicate data transfer until you
configure and enable software services.
For information about Go to
Starting the Passport 2430 for the First Time Chapter 3
Operating the Passport 2430 Chapter 4
1 2
Passport 2430
Link TX/RX
10/100 Console
Run
Boot
Fail
VLK0020A
Flash
1
2
l
O PCMCIA
Modem