Setting IP parameters for the Nortel Ethernet Routing Switch 4500 Series
41
3
Connect to the switch using the terminal or terminal emulation
application.
4
After the Nortel banner appears, press
CTRL + Y
to display the
main menu. Depending on whether the switch is stand-alone or in a
stack configuration the stand-alone switch main menu or the stack
switch main menu displays.
5
From the main menu, select
Command Line Interface...
6
To enter the Global Configuration command mode, use the
enable
command.
7
At the prompt, enter the
configure terminal
command.
8
At the prompt, enter the
ip address
command to set the switch
or stack IP address.
Following is the
ip address
command syntax:
ip address [stack | switch} <ip address> [netmak
<subnet mask>] [default-gateway <gateway address>]
The following table describes the
ip address
command
parameters.
Table 1
ip address parameters
Parameter
Description
[stack | switch]
Use either the stack or switch key word to set the
appropriate IP address.
<ip_address>
The IP address to be used.
<subnet_mask>
The subnet mask to be used.
<gateway_address>
The default gateway address to be used.
—End—
The IP configuration is now complete.
To continue configuration, use the appropriate CLI commands.
To disconnect from the switch, do the following:
Step
Action
1
To return to the Console Menu, use the
logout
command.
2
Select
Logout
from the main menu.
Nortel Ethernet Routing Switch 4500 Series
Installation Guide
NN47205-300
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
Summary of Contents for 4500 Series
Page 59: ......
